Acorn Sales Blog

Be Cautious Going Digital with Your South Dakota Engineer’s Seal Stamp
South Dakota's Department of Labor and Regulation sets rules for how an engineer's seal is displayed and used, and going digital does not suspend them. What the seal actually certifies, what the state expects of an electronic version, and what to settle before switching.

Arkansas PE Seal Rules: Size, Firm Seal and Each Page
An Arkansas engineering firm buys two kinds of seal: its own, carrying the firm name and certificate of authorization number, plus the individual seal each licensee holds. The 1-1/4 to 2 inch range, the milled edge, and the pages that must carry an imprint.

Arizona PE Embossing Stamp for Engineers
Arizona is unusual in making the rubber stamp the required device while the embossing seal stays optional, and every engineer buys it at their own expense. The inch and a half diameter, the two circle layout, and the wording that goes in the ring.

Alaska PE Embossing Seal for Engineers
Alaska specifies no size for a PE seal or stamp, though about two inches in diameter is the common choice. When the seal has to be used, what the rules say about dating a sealed document, and who pays for it.

What You Need to Know About Using an Alabama Engineer Embosser
Alabama law requires a seal on all professional engineering documents, made with either an embosser or a stamp, and the design has to meet state criteria. What the Alabama seal must show, when to buy one after licensure, and how other states differ.

What You Need to Know about the Use of Massachusetts Architecture Stamp Seal
A Massachusetts architect's seal is the visible sign of good standing under the state's Rules of Professional Conduct, which is why its physical form is prescribed. The physical requirements for the seal, and how registered architects are expected to use it.

New Jersey Architect Seal: A Board-Issued Seal Press
The rubber stamp ban everyone quotes for New Jersey belongs to the engineers' board, not the architects', whose own board supplies the seal press. Where the architects' rules actually sit, what goes on the seal, and which documents you must seal.

When You Need a Florida Architect Embossing Seal
Florida has nearly 3,700 licensed architects and a set of seal rules that changed as recently as 2013, so even long-practicing architects can find their device out of date. What Florida requires of an architect's embossing seal, and when you actually need one.

Alabama Architect Seal Requirements: Size and Design
An Alabama architect seal is circular and exactly two inches, with the legend on the outer ring and your name and number inside the inner circle. A single-ring die carrying all four items is still wrong, and the Board sends you the artwork.

Wisconsin Architect Seal: Your City Is a Required Element
Your city is a required element of a Wisconsin seal, alongside your name and credential number, and a stamp cut from a national template will lack the line. Overall diameter runs 1-5/8 to 2 inches, and the approved device list changed in June 2025.

Wyoming Architect Seal: It Proves Nothing Unless Signed
A Wyoming architect seal is prima facie evidence of responsible control only if it has been signed and dated, so an unsigned sheet gives up that presumption. The word Date: is itself a required element of the die, listed with your name and number.

Washington Architect Seal: Sign Across It, Seal Each Sheet
Washington architects sign across the seal, while the landscape architect chapter next door puts the identification adjacent: same state, two placements. Every drawing sheet gets sealed, specifications need only the cover, title and contents pages, and the page covers size and electronic seals.






